Explore a cathode-biased 12AX7/ECC83 voltage amplifier on plate-characteristic curves digitised from an RCA 12AX7-A chart. Change the resistors or B+ to move the RCA-based DC operating point, then examine the load lines and estimated voltage gain.
Estimated operating point and gain
RCA 12AX7-A characteristic curves and load lines
The grey curves are traced from the RCA chart at grid-to-cathode voltages in 0.5V increments. The green line is the DC plate load line. The purple dashed curve represents the cathode self-bias relationship between grid voltage and plate current. Its intersection with the green line determines the estimated operating point.
The cathode self-bias curve is calculated using the same RCA characteristics as the operating-point calculation. Only sections supported by the digitised data are shown.
RC-only gain response: 40 Hz to 10 kHz
This is not a complete frequency-response prediction. The graph includes the guitar's low E (82.4Hz) and reference points at 1kHz, 5kHz and 10kHz. It shows the estimated effects of the cathode bypass capacitor, coupling capacitor and following-stage load. It does not include Miller capacitance, preceding-stage source impedance, grid-stopper effects or stray capacitance. The vertical dB scale adjusts automatically.
What is changing?
--
--
--
--
Gain comparison at guitar frequencies
| Frequency | Loaded gain | Gain (dB) | Relative to 1 kHz |
|---|
How this version calculates the operating point
The curves are digitised samples of the RCA 12AX7-A plate-characteristic chart. Values between plotted samples and grid-voltage curves are interpolated.
The DC load line is calculated from the supply voltage and the plate and cathode resistors.
Self-bias requires the grid-to-cathode voltage to equal the negative of plate current multiplied by cathode resistance.
The purple cathode self-bias curve shows the plate voltage and current combinations satisfying that relationship on the RCA characteristic curves. Its intersection with the DC load line is the Q point.
Small-signal plate resistance and amplification factor are estimated locally around Q. AC voltage gain uses the resistor values and complex capacitor impedances.
The dashed AC load line is displayed only when the circuit is approximately resistive at 1kHz. With partial cathode bypassing, the AC impedance is complex and a single straight AC load line is not generally appropriate.
If the operating point falls outside the available RCA curve data, the calculator does not extrapolate an operating point.
No comments:
Post a Comment